Revolving Punch Plier Kit, Leather Hole Punch Set for Belts

A closer look

A dull punch tears the back side of a watch band or leaves frayed threads in canvas. This plier carries six hollow cutting tubes on a rotating wheel so you can dial in the hole you need without hunting for loose dies. Squeeze it in the palm or swing the base bracket down to steady the lower jaw directly on your work surface.

• Rotating steel wheel. Turn the turret by hand to bring the selected tube into position over the lower anvil. The cutter clicks firmly into alignment so each strike meets the flat base square on, cutting clean through without tearing leather fibers.
• Fold-down table rest. A swinging bracket on the lower handle folds out to support the tool on your benchtop. This lets you press downward with full body weight when driving through thick belt leather or layered canvas instead of relying only on grip squeeze.
• Plated steel frame. We build the frame from hardened plated steel finished with a sprayed lacquer coat to resist workshop moisture. The hollow cutting tapers stay sharp through repetitive punching in leather, rubber gasket stock, dense cardboard, and heavy webbing.
• Matched size markings. Each tube size is stamped on the wheel hub so you can see which punch is engaged before pressing down on a finished strap. Check the label beside this for the specific hole measurements ground into the cutting head.